About How To Clean And Disinfect The Snowflake Ice Machine, You Will Know After Reading This Article

About how to clean and disinfect the snowflake ice machine, you will know after reading this article

The snowflake ice machine automatically enters a water storage tank through the water inlet valve, and then pumps water to the shunt pipe. The shunt pipe evenly flows the water to the evaporator cooled by the low-temperature liquid refrigerant, and the water is cooled to the freezing point. The water cooled to freezing point will solidify into ice, and the water not frozen by the evaporator will flow into the water storage tank again, and the circulation will start again through the water pump.

When the ice cube reaches the required thickness, it enters the deicing state, and the high-pressure hot gas discharged from the compressor is diverted to the evaporator through the reversing valve to replace the low-temperature liquid refrigerant.

In this way, a layer of water film is formed between the ice cubes and the evaporator. This water film makes the ice cubes leave the evaporator, and the ice cubes fall freely into the ice storage tank below under the action of gravity.

Next, let's take a look at how to clean and disinfect the snowflake ice machine. Without further ado, let's take a look.

Operation procedures for disassembling parts for cleaning (or disinfection):

(1) Turn off the water source of the ice machine and cut off the power supply;

(2) Remove the parts that need to be cleaned (or disinfected), such as the water curtain plate and the water distribution pipe;

(3) Soak the disassembled parts in an appropriate amount of cleaning (or disinfecting) solution. The ratio of the solution is shown in the table below: solution category water cleaning/disinfectant dosage cleaning solution 1 gallon (4 liters) 16 ounces (500 ml) 4 gallons (15 liters) 3 ounces (90 milliliters) of sanitizing solution;

(4) Clean the parts carefully with a soft bristle brush or sponge (do not use a metal brush);

(5) Clean the top, side and bottom of the protruding part of the evaporator with solution and brush;

(6) Rinse all cleaned (or disinfected) parts with clean water*.

Precautions for cleaning (or disinfection) of snowflake ice machine:

(1) When using ice machine cleaners and disinfectants, please wear rubber gloves and protective goggles, and it is recommended to wear a face shield;

(2) Only cleaning agents and disinfectants are allowed

(4) Cleaning and disinfection should be carried out separately. Clean first and then disinfect. Do not mix cleaning agents and disinfectants;

(5) After adding cleaning agent or disinfectant, do not artificially stop the cleaning (or disinfection) process, otherwise there will be cleaning agent or disinfectant remaining in the machine.

The above content is to share with you the relevant cleaning and disinfection methods of the Snowflake Ice Machine. I hope that everyone can have a better understanding of the product after reading it.