How to Correctly Choose a Commercial Flake Ice Machine

In order to help customers better choose and use flake ice machines, flake ice machines, flake ice machines or block ice machines, the correct way to use these machines should be:

1. The flake ice machine should be installed away from heat sources, without direct sunlight, and in a well-ventilated place. The ambient temperature should not exceed 35 degrees Celsius to prevent the high ambient temperature from causing poor cooling of the condenser and affecting the ice-making effect. The ground where the flake ice machine is installed should be solid and flat, and the flake ice machine must be kept level, otherwise it will cause no deicing and noise during operation.

2. The gap between the back and the left and right sides of the flake ice machine should not be less than 30cm, and the gap at the top should not be less than 60cm.

3. The flake ice machine should use an independent power supply, dedicated line power supply and equipped with fuses and leakage protection switches, and must be reliably grounded.

4. The water used by the flake ice machine must meet the national drinking water standards, and a water filter device should be installed to filter impurities in the water, so as not to block the water pipe and pollute the water tank and ice mold. And affect the ice making performance.

5. When cleaning the flake ice machine, the power should be turned off. It is strictly forbidden to use a water pipe to directly point at the machine body to rinse, and use a neutral detergent to scrub it.

6. The flake ice machine must unscrew the head of the water inlet hose for two months to clean the filter screen of the water inlet valve to avoid sand and mud impurities in the water from clogging the water inlet, which will cause the water inlet to become smaller, resulting in no ice making.

7. The flake ice machine must clean the dust on the surface of the condenser every two months. Poor condensation and heat dissipation will cause damage to the compressor components. When cleaning, use a vacuum cleaner, a small brush, etc. to clean the oil and dust on the condensation surface, and do not use sharp metal tools to clean, so as not to damage the condenser.

8. The water pipes, sink, storage bin and protective film of the flake ice machine should be cleaned every two months.

9. When the flake ice machine is not in use, it should be cleaned, and the ice mold and the moisture in the box should be blown dry with a hair dryer. It should be placed in a dry and ventilated place without corrosive gas, and should not be stored in the open air.