Basic knowledge of flake ice machine and common troubleshooting methods
Leave a message
Basic knowledge of flake ice machine and common troubleshooting methods
Flake ice machine is a commonly used refrigeration equipment that can freeze water, ice cubes or other liquids into solids. It usually consists of a compressor and two evaporators. When working, the compressor sucks in air or liquid, then heats and compresses it to a certain temperature and then releases it. The expanding gases push the piston down. At the same time, the condensed liquid droplets absorb heat and convert into refrigerant to cool the solution in the evaporator. The solution in the evaporator is pumped into the main vacuum pump before the compressor is turned off. When you need to use the flake ice machine, you must first connect the power to the flake ice machine. At this time, the controller will indicate the amount of ice water/ice balls you need and the corresponding cooling capacity. Then, press the "refrigeration" button to switch the flake ice machine to freezing mode, and the compressor cannot be turned on until the switch contacts are separated from the control board.
Troubleshooting methods for common faults of flake ice machines
Troubleshooting methods for common faults of the flake ice machine: 1. Loose handle When the handle of the flake ice machine is loose, it may be caused by improper use. Check whether the handle is loose and retighten it in time. 2. The slider is stuck If the slider is stuck on the flake ice machine, it is usually caused by the wear of the sliding parts. Care should be taken to check the correct position of the slides, friction between parts or unusual noises. 3. The control panel does not work When the flake ice machine fails to work normally, it is usually caused by damage to the circuit board or other components on the control panel. Damaged components should be replaced immediately to ensure the normal operation of the machine. 4. The motor does not rotate When the flake ice machine vibrates but the motor does not rotate, it is generally because the impeller bearings are not effectively fixed.
