The flake ice machine is mainly used to make ice flakes, and its usage is as follows

The flake ice machine is mainly used to make ice flakes, and its usage is as follows:

1. First place the flake ice machine on a level surface and plug the machine into the power cord.
2. Open the top cover of the machine and put the ice cubes to be made into the ice cube basket inside the machine.
3. Adjust the parameters of the machine as needed, such as the size of ice cubes and production speed, etc. (the adjustment methods of these parameters may vary with different brands and models of flake ice machines, please refer to the relevant instruction manual).
4. Press the start button on the machine, the machine will start to make ice flakes.
5. When the ice flakes are finished, turn off the machine and take out the ice flakes.
6. Clean the ice cube basket and the inside of the machine, ready for the next use.

It should be noted that when using the flake ice machine, it must be operated correctly according to the equipment instruction manual, and at the same time ensure its own safety. In addition, regular inspection and maintenance of equipment is required to ensure the normal operation and life of the equipment.

Precautions for ice machines:

1. The ice machine should not be placed in the open air. It is better to install it in a safe, clean and well-ventilated environment, and it should not be exposed to direct sunlight or rain.

2. The ice machine should not be close to the heat source, and the operating environment should not be lower than 5°C and not higher than 40°C, so as not to affect the heat dissipation of the condenser due to high temperature and fail to achieve a good ice-making effect.

3. The ice machine should be installed on a stable platform, and the anchor screws at the bottom of the machine should be adjusted to ensure that the machine is placed horizontally, otherwise it will cause no deicing and noise during operation. Space should be left around, in order to facilitate heat dissipation, the space on the left, right and rear of the machine should not be less than 150mm.

4. The ice machine should use the specified independent power supply that meets the national standards. The power supply should be reliably grounded, and equipped with fuses and leakage protection switches. The voltage fluctuation should not exceed ±10% of the rated voltage.

5. The ice machine should use water sources that meet local drinking water standards, and install filters to remove impurities in the water, avoid blocking water pipes, polluting water tanks and ice molds, and affecting ice-making performance. The minimum water temperature is 2°C, the maximum is not more than 35°C, the minimum water pressure is 0.02Mpa, and the maximum is 0.8Mpa.

6. The ice machine must unscrew the head of the water inlet hose for two months to clean the filter screen of the water inlet valve to avoid sand and mud impurities in the water from clogging the water inlet, causing the water inlet to become smaller and resulting in no ice making. Although the ice machine will drain the cooled remaining water in the water tank at the end of each ice-making process to achieve the cleaning effect, which can effectively reduce the scale generation in the evaporator and water circulation system, but generally six months Left and right, the water distribution pipes, sinks, storage bins and water baffles should also be cleaned and disinfected with ice machine cleaners and disinfectants, and rinsed. The ice cubes produced during the cleaning process cannot be eaten. When not in use for a long time, it should be cleaned, and the ice mold and the moisture in the box should be blown dry with a hair dryer, and placed in a dry and ventilated place without corrosive gas, avoiding open storage.

7. When transporting the ice machine, handle it with care to prevent violent vibrations. The inclination of the transport should not be less than 45 degrees. After long-distance transportation, the ice machine should be placed for 2-6 hours before it can be turned on to make ice.