The Amount Of Ice Produced Is Directly Related To The Service Life Of The Machine, How To Use And Maintain It?

Transportation and installation

During transportation and handling, beware of collision, vibration, tilting, inversion, etc. so as not to loosen or damage parts.
parts inspection
According to the packing list, check whether the machine and parts are complete, and whether the model is consistent with the order.
Check whether the outer packaging is damaged and whether the internal components are loose or damaged.
Check whether all pipe connections (water system, refrigeration system), electrical connections and mechanical systems are in good condition.
Installation conditions
The socket and wiring must comply with the local electrical regulations and the requirements on the nameplate of the machine.
The main power switch of the power supply must be within reach, and the ground wire must be installed according to relevant regulations.
The machine must ensure continuous water supply, the water source switch must be installed near the ice maker, the water inlet pipe must be independent, and the drain must be not far from the ice maker and lower than the drain of the ice maker.
The distance from the wall around the machine is at least 150mm to ensure sufficient ventilation.
The ice machine cannot be installed outdoors and in a sealed environment or near a heat source.
In order to ensure the quality of the ice produced, according to the water quality conditions in various places, you can consult the installer whether it is necessary to install a water filter or a water processor.
installation steps
A. Check whether the machine is level, and use the feet to adjust the level of the machine.
B. Connect the water source with the water inlet pipe provided with the machine.
C. Connect the drain outlet with the drain pipe provided with the machine, and set the slope not less than 4mm/M.
D. Open the water supply valve and check whether there is water leakage in the system water pipe.
E. Plug in the power plug of the machine, turn the power switch under the transom to the "on" position, and the machine will enter the automatic ice making state.
F: In order to ensure the normal operation of the ice machine, please install and maintain it correctly under the guidance of the wholesaler or supplier.
Operating procedures and methods of use
Start-up: After confirming that the water source and power supply are normal, turn on the water source, connect the power supply, and the ice machine will enter the automatic ice-making state.
Ice Harvesting Process: The ice machine will go through the deicing process first when it is started for the first time or when it is shut down and restarted. The compressor and the fan motor start to run, and the defrosting solenoid valve and the water inlet solenoid valve are opened (time setting control or temperature control control).
Ice-making process: After harvesting, the water inlet solenoid valve and defrosting solenoid valve are closed, the water pump starts to run, and the water in the water spray pipe enters the inner layer of the ice tray to freeze, and the ice is full to a certain extent and repeats the "2" harvesting process. process.
Automatic shutdown: When the ice machine is in normal working condition, it will automatically repeat the ice harvesting and ice making actions until the ice tank is full of ice, and it will automatically turn on after the ice cubes are taken away.