How to use the ice machine? What are the precautions for use?

How to use the ice machine?

1. Before use, check whether the various devices of the ice machine are normal, for example, whether the water supply device is normal, whether the water in the water tank is normal (some water tanks have been set before leaving the factory).

2. After the ice machine works normally, put the ice machine in a stable position, and insert the prepared bottled water into the water inlet of the ice machine. At this time, the sea water will automatically enter the water tank of the ice maker.

3. After the power supply of the ice machine is plugged in, the ice machine starts to work, and the water pump is pumped from the water tank to the ice making area. At the beginning, the ice machine has a process of exhausting air, and after the air is exhausted, it will be compressed The machine starts and enters the working state, and the ice machine starts to enter the ice making state.

4. When the ice thickness in the ice machine reaches the thickness set by the ice machine, the ice plate probe in the ice machine starts to work. When the defrosting solenoid valve works, the water pump stops working, hot air enters the evaporator, and the ice cubes start to work. decline.

5. When the ice cubes start to fall, flip the baffle and turn on the reed switch. When a certain amount of ice cubes arrive, the magnetic spring will close again, and the ice maker will enter the ice making state again.

6. When the ice bucket of the ice machine is full of ice, the reed switch will not automatically close, the ice machine will stop working automatically, and the ice making will be completed. For example, turn off the power switch of the ice machine, unplug the power of the ice machine, and the ice making is over.

Precautions for using the ice machine:

1. The ice machine should be installed in a place away from heat sources, avoiding direct sunlight, and in a well-ventilated place. The ambient temperature should not exceed 35°C, so as not to cause poor cooling of the condenser due to excessive ambient temperature and affect the ice-making effect. The ground of the ice machine should be flat and level, and the ice machine must be kept level, otherwise it will cause no deicing and running noise.

2. The gap between the back of the ice machine and the left and right sides is not less than 30cm, and the gap at the top is not less than 60cm.

3. The ice machine should use an independent power supply, dedicated line power supply, and equipped with fuses and leakage protection switches, and should be reliably grounded.

4. The water used by the ice machine should meet the national drinking water standards, and a water filter device should be installed to filter impurities in the water so as not to block the water pipes and pollute the pool and ice molds. Affects ice making performance.

5. When cleaning the ice machine, the power should be turned off. It is strictly forbidden to directly wash the machine body with a water pipe, and use a neutral detergent to scrub it. It is strictly forbidden to use acidic, alkaline or corrosive solvents for cleaning.

6. The ice machine needs to be screwed into the water hose head for two months to clean the filter screen of the water inlet valve to avoid sand and mud impurities in the water from clogging the water inlet, resulting in a smaller water intake and no ice making.