What Are The Necessary Items To Check Again After The Ice Machine Is Installed?

The steps to be checked before the ice machine is commissioned:

1: Observe whether the oil level in the oil sight glass of the ice machine reducer meets the requirements.

2: Whether the fixing screw is locked.

3: Whether the power wiring of each motor is firm and whether the grounding is reliable.

4: Open the water inlet valve to supply water to the circulating water tank, and the water level is about 2/3 of the height of the water tank.

5: Commissioning and use (after correct installation).

Open the water supply valve and check the water level in the tank.

Start-up: Turn on the power switches QF1 and QF2, put the run/standby knob at the "Run" position, the system enters the start-up process, after a delay of 10 seconds, the reducer, water pump and condenser fan will start, and the delay will be 30 seconds to compress The machine and the liquid supply solenoid valve start, the compressor lubricating oil heater stops heating, and the system can normally produce ice after 5-8 minutes of normal startup.