The Evaporator Of The Flake Ice Machine Is A Key Component Of The Flake Ice Machine

The evaporator of the flake ice machine is a key component of the flake ice machine

The ice machine evaporator is a key component of the flake ice machine, which is responsible for ice making. The evaporator of the flake ice machine is a vertical bucket structure with ice blades, which is the main component of ice making. Driven by the reducer, the ice blades of the flake ice machine, the main shaft of the flake ice machine, and the sprinkler tray rotate slowly counterclockwise. Water enters the water distribution tray from the water inlet of the evaporator of the ice machine, and through the sprinkler pipe, the water is evenly sprinkled on the inner wall of the evaporator to form a water film; the water film exchanges heat with the refrigerant in the flow channel of the evaporator, and the temperature drops rapidly. A thin layer of ice is formed on the inner wall of the evaporator, and under the extrusion of the ice blade, it breaks into flakes of ice and falls into the ice storage from the ice outlet. Part of the unfrozen water returns to the cold water tank from the water return port through the water receiving tray, and the flake ice machine passes through the cold water circulation pump. To match different evaporators

ice making process

⑴Before starting up, check whether the automatic water supply device is normal and whether the water storage in the water tank is reasonable (the water level has been adjusted to the right level when the machine leaves the factory, and the user does not need to adjust it).

⑵Plug in the power supply, the ice machine starts to work, first the water pump starts to run (the water pump has a short-term air exhaust process), and after about 2 minutes, the compressor starts to start, and the machine enters the ice making state.

(3) When the thickness of the ice cube reaches the set thickness, the ice plate probe starts to start, the defrosting solenoid valve starts to work, the water pump stops working, the hot air enters the evaporator, and the ice cube falls in about 1 minute. As the ice cubes fall, flip the ice flap over and open the reed switch. When the magnetic reed switch is closed again, the machine enters into another ice making process.

⑷The compressor does not stop during the whole process of ice making and deicing.

⑸When the ice bucket is full of ice and the magnetic reed switch cannot be closed automatically, the machine will stop working automatically. When enough ice cubes are removed and the magnetic reed switch is closed again, the machine will start up after a delay of 3 minutes and re-enter the ice making process .