How To Deal With The Problem Of Ice Jam in The Small Ice Machine
Leave a message
The ice of the small ice machine is through the water inlet valve, the water automatically enters the water storage tank, and then the water is pumped to the shunt pipe by the water pump, and the shunt pipe flows the water evenly to the evaporator cooled by the low-temperature liquid refrigerant, and the water is cooled to Freezing point, when it reaches the freezing point, it will naturally freeze to ice, and the water that has not been frozen by the evaporator flows into the water storage tank, and the water pump starts to work again and again.
When the ice cube reaches the required thickness, it enters the deicing state, and the high-pressure hot gas discharged from the compressor is diverted to the evaporator through the reversing valve to replace the low-temperature liquid refrigerant, so that a layer of water film will be formed between the ice cube and the evaporator. When the water film leaves the evaporator, the ice cubes will automatically fall into the ice storage tank by gravity, but what to do if the ice is stuck?
Here are a few solutions for you:
1: Failure of the refrigeration system: In the process of inspection, it is necessary to see, listen, and touch to see whether the system is operating normally. Once the operating pressure and temperature exceed the normal range, there must be a malfunction in addition to the deterioration of the indoor and outdoor temperature.
2: The water pump is insufficient or there is no water: the water pump is broken and cannot press the water to the ice tray, and there will be no ice. It is necessary to clean the water pump frequently, preferably once a month or two, to prevent jams The ice phenomenon affects the ice making effect.
3: Defective phenomenon of the radiator: the ice making time is too long, the heat dissipation is not good, the compressor is overheated and the ice is not made, and the dust on the heat sink needs to be cleaned. The ice machine is not air-cooled, and needs to use a water-filled condenser to discharge the heat.
