Common Faults And Solutions For Ice Machines in Some Milk Tea Shops

Drinking a cup of icy cold drink in the hot summer is something that many young people prefer now. Therefore, the ice machine in the milk tea shop has become one of the indispensable equipment. However, as a high-frequency equipment, it is inevitable that there will be some failures. Those who open a shop must understand the relevant equipment and learn simple troubleshooting. Today, the editor will talk about common failures and solutions of ice machines.

no ice

1. Not placed horizontally - required to be placed horizontally

2. The ice plate probe is faulty or too close—replace or adjust the ice plate probe

3. Is the solenoid valve leaking - replace the solenoid valve and filter

4. Refrigerant leakage - check for leaks and repair welding and vacuumize and add refrigerant.

 

loud noise

1. The fan is noisy - check the fan blades, install the screws, correct or fasten them

2. Whether the chassis is deformed - adjust

3. The compressor itself is noisy - adjust and replace

4. Refrigeration system pipeline matcha - adjust the pipeline route

 

no water, no water

There are two situations:

1. The water pump works but does not supply water

1. There is air in the pipeline - discharge the air in the pump

2. There is too much ice slag at the bottom - shut down and restart drainage

3. The impeller of the water pump is worn - replace the water pump

 

2. The water pump does not work

There are two possibilities:

1. The water pump is broken - replace the water pump

2. Poor wiring or circuit board failure - check the circuit or replace the circuit board.

There is ice on the upper part of the ice tray but no ice or thin ice on the lower part

1. The installation of the ice tray is too inclined - adjust the installation

2. Few types of refrigerant - add refrigerant appropriately after determining the type of refrigerant

3. Not placed horizontally - placed horizontally

 

Compressor does not start

1. Low voltage - adjust the voltage

2. Check the starter protector - replace if damaged

3. Whether the compressor is normal - if it is not normal, replace the compressor

 

Not enough heat dissipation

1. Not ventilated - adjust the position of the vent

2. The condenser is dirty - clean the condenser

 

no water

1. The water inlet valve is blocked - clean the net cover (according to the water dispenser filter)

2. The water inlet valve is broken - replace the water inlet valve

3. The socket on the circuit board is loose or the circuit board is broken - check the circuit board, or replace the circuit board

4. The water level sensor switch is broken - replace the water level sensor switch
5. The return of the ice baffle is not normal - adjust.