What are the precautions for equipment installation of ice machine manufacturers
Leave a message
What are the precautions for equipment installation of ice machine manufacturers
1. Pay attention to the placement of the ice machine
Although the ice machine is a machine specially developed and produced by the ice machine manufacturer to make ice cubes, but because the power is relatively large and the engine will generate more heat during the ice making process, it needs to be dissipated in time, otherwise it will be damaged. It will cause damage to the machine, so it should be placed in a place with good heat dissipation effect. This is a problem that an expert must understand. And the manufacturer of the ice machine emphasizes that it must be placed indoors. The bad weather outside will cause damage to the machine, so protection measures must be taken to prevent rain and sunlight from directly damaging the machine.
Second, pay attention to the installation of the water system
Because the ice machine products produced by ice machine manufacturers need to use water as a raw material to make ice cubes, there is a very important water system installation process. The ice machine manufacturer emphasizes that in order to make the ice cubes produced meet the standard requirements, it must first be connected to a clean water source that meets drinking water standards and must also undergo a filter. Therefore, it is necessary to pay attention to these details during installation. The water used must also meet the temperature and water pressure within the range required by the standard.
3. Pay attention to the installation of the power supply
When installing the equipment of the ice machine manufacturer, it is necessary to understand clearly the voltage and power type required by the ice machine, and must be adjusted according to the above regulations to be consistent with the one marked on the machine nameplate. And the ice machine manufacturer and supplier emphasized that the arrangements for the next month must meet the national standard requirements. At the same time, in order to prevent lightning strikes, the ground wire must be used, and a stable voltage supply should be guaranteed, and the voltage fluctuation should be within the specified range.
The above are a few things that need to be paid attention to during the installation process of ice machine manufacturers. In addition, it should be handled with care, hands and feet should be gentle, and the machine should not be violently vibrated, especially when handling it. at this point. At the same time, the ice machine manufacturer reminds that the power supply must be independent and cannot be shared with other machines, and a leakage protection switch must be installed.
