Ice Maker Ice Status Workflow

Ice Maker Ice Status Workflow

1. Insert the prepared bottled water into the water inlet of the ice machine. At this time, the water will automatically enter the water tank of the ice maker.

2. After plugging in the power of the ice machine, the ice machine starts to work, and the water pump starts to run to pump the water in the water tank into the ice making area. At the beginning, the water pump has a process of exhausting the air. After the air is exhausted, the compressor starts to start. And enter the working state, the ice machine starts to enter the ice making state.

3. When the thickness of the ice cubes in the ice machine reaches the thickness set by the ice machine, the ice plate probe in the ice machine will start to work, and at the same time the defrosting solenoid valve will work, while the water pump will stop working and the ventilation valve will open Hot air enters the evaporator and the ice cubes begin to fall.

4. When the ice storage bucket of the ice maker is full of ice cubes, the magnetic reed switch will not close automatically, the ice maker will stop working automatically, and the ice making will be completed.