Learn About The Working And Operating Principle Of The Granular Snowflake Ice Machine

Learn about the working and operating principle of the granular snowflake ice machine

The granular snowflake ice machine is a kind of mechanical and electronic equipment for automatic ice-discharging granular snowflake ice making that water passes through an evaporator and is cooled by the refrigeration technology system as a refrigerant to generate ice.

The art design of the living environment in modern society often needs to use the automatic ice granule snowflake ice machine, but many people do not understand it.

Now let's take a look at the working principle of the granular snowflake ice machine and its operation method.

1. The frozen water in the water storage tank of the automatic ice-discharging granule snowflake ice machine is continuously circulated through the plate type or split type evaporator through the water pump.

2. After the compressor of the automatic ice-discharging particle snowflake ice machine works, it goes through suction-compression-exhaust-condensation (liquefaction)-throttling-and then evaporates in the evaporator at a low temperature of -10 to -18 degrees. heat vaporization. Frozen water continuously condenses into an ice layer through the surface of the evaporator at a lower temperature at a water temperature of 0 degrees. When the ice layer condenses to a certain thickness, the evaporation ambient temperature of the refrigerant can reach the different temperature set by the intelligent temperature control, and then the defrosting control solenoid valve is turned on. Traditional heat pump technology is often used for deicing. Realize the next development cycle of the enterprise.

3. Ice cycle of the automatic ice-out granular snowflake ice-making mechanism:

Through the supplementary water valve, the water is automatically controlled into a water storage tank, and then the water is sent to the splitter head through the flow pressure control valve through the electronic water pump system, where the water is evenly sprayed on the surface of the ice maker, like a water curtain The same can flow through the wall of the ice maker, the water is cooled to the freezing point, and the water that is not evaporated and frozen will flow into the water storage tank through the research porous groove, and the redesign begins to develop the circulation management work.

4. Ice harvesting cycle of the automatic ice granule snowflake ice machine:

When the ice reaches the desired thickness (the thickness can be arbitrarily selected by the operator/user), the hot air discharged from the compressor is reintroduced into the clamping wall of the ice machine to replace the low-temperature liquid refrigerant. This creates a thin film of water between the ice and the evaporator walls, which lubricates the ice as it falls freely under gravity into the trough below. The water produced during the harvest cycle will be returned to the storage tank through the perforated slot, which also prevents the wet ice from being drained by the automatic pellet snow ice machine.

5. Concentration of automatic ice granule snowflake ice machine:

There are air-cooled, water-cooled or evaporative condensers. The evaporator is installed above the automatic ice-discharging granular snowflake ice machine, and the water-cooled condenser is installed below the automatic ice-discharging granular snowflake ice machine or the refrigeration system. The air-cooled condenser can be combined with the automatic ice-discharging granular snowflake according to the actual situation. Ice machine installed together or installed outdoors. When necessary, the water-cooled condenser of the automatic ice-discharging pellet snowflake ice machine can be used on board or along the coast, cooled with sea water. Evaporative cooling can be used when the ambient air temperature is high, but from the perspective of efficiency and economy, it is not suitable for water cooling or air cooling.